Pacific Radio (M) Sdn Bhd
[16370-U]
80, Jalan Pasar, Pudu,
55100 Kuala Lumpur,
Malaysia.
 +603-9221 8631 (6 Lines)

 +603-9221 4216
 +603-9221 3867
 +603-9221 8630

 +603-9223 4109
 
Pacific Electronic (S) Pte Ltd
1 Rochor Canal Road,
#01-10/11/12,
Sim Lim Square,
Singapore 188504.
 +65-6294 0851
 +65-6337 1132
 +65-6339 5884
 +65-6339 8454
 +65-6338 3609

DBX Processors 1066 compressor Limiter, Gate

Previous 8 / 11 Next

DBX Processors 1066 compressor Limiter, Gate DBX Audio Equipments


Specifications:

Input Connectors XLR and 1/4" TRS (Pin 2 and tip hot)
Input Type Electronically balanced/unbalanced, RF filtered
Input Impedance Balanced > 50 kOhm, unbalanced >25 kOhm
Max Input > +24 dBu balanced or unbalanced
CMRR Typically >50 dB at 1 kHz
Output Connectors XLR and 1/4" TRS (Pin 2 and tip hot)
Output Type Servo-balanced/unbalanced, RF filtered
Output Impedance Balanced 120 Ohm, unbalanced 60 Ohm
Max Output > +21 dBm balanced, > +20 dBm unbalanced
Sidechain Input Connector 1/4" Unbalanced (Tip-Sleeve)
Sidechain Input Type Unbalanced, RF filtered
Sidechain Impedance >10 kOhm
Sidechain Max Input Level >+24 dBu
Sidechain Output Connector 1/4" Balanced TRS (tip hot)
Sidechain Output Type Impedance balanced, RF filtered
Sidechain Output Impedance Balanced 2 kOhm, unbalanced 1 kOhm
Sidechain Max Output Level >+21 dBu balanced or unbalanced
Bandwidth 20 Hz to 20 kHz, +0/0.5 dB
Frequency Response 0.35 Hz to 90 kHz, +0/-3 dB
Noise < -95 dBu, unweighted, 22 kHz measurement bandwidth
Dynamic Range > 118dB, unweighted
THD+Noise 0.008% typical at +4 dBu (1 kHz unity gain), 0.08% typical at +20 dBu (1 kHz unity gain), < 0.1% any amount of compression up to 40 dB, 1 kHz
IMD < 0.1% SMPTE
Interchannel Crosstalk < -80 dB 20Hz to 20 kHz
Stereo Coupling True RMS Power Summing
Compressor Threshold Range -40 dBu to +20 dBu
Compressor Ratio 1:1 to infinity:1
Compressor Threshold Characteristic Selectable OverEasy® or hard knee
Compressor Attack/Release Characteristic AutoDynamic™
Compressor Attack/Release Modes Selectable Manual or Auto
Compressor Manual Attack Time Scalable program-dependent
Compressor Manual Release Time Scalable program-dependent
Compressor Auto Attack Time Program-dependent
Compressor Auto Release Time Program-dependent
Compressor Output Gain -20 to +20 dB
Limiter Threshold Range +4 dBu to +24 dBu (off)
Limiter Ratio infinity:1
Limiter Type PeakStopPlus® two-stage limiter
Limiter Stage 1 PeakStop® brickwall limiter
Limiter Stage 1 Attack Time Zero
Limiter Stage 1 Release Time Zero
Limiter Stage 2 Predictive intelligent program limiter
Limiter Stage 2 Attack Time Program-dependent
Limiter Stage 2 Release Time Program-dependent
Expander/Gate Threshold Range Off to +15dBu
Expander/Gate Ratio 1:1 to 30:1
Expander/Gate Attack Time < 100 µsec
Expander/Gate Release Time Program-dependent
SC Ext. Switch Routes the external sidechain input signal to the detector
SC Mon. Switch Routes the sidechain signal to the output, interrupting the normal audio
OverEasy® Switch Activates the OverEasy compression function
Countour Switch Activates the frequency-dependent detector function
Auto Switch Activates automatic program-dependent attack and release times, disabling the manual Attack and Release controls
I/O Meter Switch Switches between monitoring input and output levels on the Input/Output Level meter
Bypass Switch Activates the direct input-to-output hard-wire relay bypass. Relay automatically hard-wire bypasses unit at power-down and provides a power-on delay of 1.5 sec.
Operating Level Switch (rear panel) Switches the nominal operating level between -10 dBV and +4 dBu simultaneoulsy for both input and output levels
ST Link Switch Link both channels for stereo operation. Channel One becomes the master
Gain Reduction Meter 12-segment LED bar graph at 1, 2, 4, 6, 9, 12, 15, 18, 21, 24, 27 and 30 dB
I/O Meter 8-segment LED bar graph at -24, -18, -12, -6, 0, +6, +12, and +18 dBu
Compressor Threshold Meter 3-segment LED bar graph at Below (-), OverEasy and Above (+)
Expander/Gate Threshold Meter 2-segment LED bar graph at Below (-) and Above (+)
Limiter Threshold Meter 1 LED to indicate PeakStopPlus™ limiting
Function Switches LED indicator for each front-panel switch
Output Transformer Options Jensen® JT-123-dbx or JT-11-dbx, BCI RE-123-dbx or RE-11-dbx
Operating Voltage 100-120 VAC 50/60 Hz 200-240 VAC 50/60 Hz
Power Consumption 20 Watts
Fuse 100-120 VAC:250 mA Slow Blow, 200-240 VAC:125 mA Type T
Power Connector IEC receptacle
Dimensions 1.75"Hx19"Wx9"D (4.4cmx48.3cmx20.1cm)
Unit Weight 5.1 lbs. (2.3 kg)
Shipping Weight 7.5 lbs. (3.4 kg)
Please leave your enquiry here, we will reply as soon as possible.
Name*  
Company Name  
Product Interested  
Quantity  
Email*  
Contact No.*  
Ship to Name  
Shipping Address  
Messages*  
   

Switch to Mobile Version